WikiDoc MAKES NO GUARANTEE OF VALIDITY. WikiDoc is not a professional health care provider, nor is it a suitable replacement for a licensed healthcare provider. WikiDoc is intended to be an educational tool, not a tool for any form of healthcare delivery. The educational content on WikiDoc drug pages is based upon the FDA package insert, National Library of Medicine content and practice guidelines / consensus statements. WikiDoc does not promote the administration of any medication or device that is not consistent with its labeling. Please read our full disclaimer here.
Overview
Sodium chloride (injection) is a fluid that is FDA approved for the treatment of volume depletion. Common adverse reactions include fluid and/or solute overloading resulting in dilution of serum electrolyte concentrations, overhydration, congested states of pulmonary edema.
Adult Indications and Dosage
FDA-Labeled Indications and Dosage (Adult)
Intravenous solutions containing sodium chloride are indicated for parenteral replenishment of fluid and sodium chloride as required by the clinical condition of the patient.
Dosage
The dose is dependent upon the age, weight and clinical condition of the patient.
Drug Interactions:
Additives may be incompatible. Consult with pharmacist, if available. When introducing additives, use aseptic technique, mix thoroughly and do not store.
Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit.
INSTRUCTIONS FOR USE
Tear outer wrap at notch and remove solution container. Some opacity of the plastic due to moisture absorption during the sterilization process may be observed. This is normal and does not affect the solution quality or safety. The opacity will diminish gradually.
Check for leaks by squeezing container firmly. If leaks are found discard unit as sterility may be impaired. If supplemental medication is desired, follow directions below before preparing for administrations.
To Add Medication
(Use aseptic technique)
Prepare medication port.
With a needle of appropriate length, puncture resealable additive port and inject. Withdraw needle after injecting medication.
Mix container contents thoroughly.
Preparation for Administration
(Use aseptic technique)
Note: See appropriate I.V. administration set Instructions For Use.
Close flow control clamp on the administration set.
Remove cap from sterile administration set port at bottom of container by securely grasping the flanges and twisting as indicated below.
Insert piercing pin of administration set into port with a twisting motion until the pin is firmly seated.
Suspend container.
If the administration set contains a drip chamber, squeeze and release to establish proper fluid level in chamber.
Open clamp. Eliminate air from remainder of set.
Attach set to patient access device.
Begin infusion.
WARNING: Do not use flexible container in series connections.
Off-Label Use and Dosage (Adult)
Guideline-Supported Use
There is limited information regarding Off-Label Guideline-Supported Use of Sodium chloride (injection) in adult patients.
Non–Guideline-Supported Use
There is limited information regarding Off-Label Non–Guideline-Supported Use of Sodium chloride (injection) in adult patients.
Pediatric Indications and Dosage
FDA-Labeled Indications and Dosage (Pediatric)
There is limited information regarding FDA-Labeled Use of Sodium chloride (injection) in pediatric patients.
Off-Label Use and Dosage (Pediatric)
Guideline-Supported Use
There is limited information regarding Off-Label Guideline-Supported Use of Sodium chloride (injection) in pediatric patients.
Non–Guideline-Supported Use
There is limited information regarding Off-Label Non–Guideline-Supported Use of Sodium chloride (injection) in pediatric patients.
Contraindications
None known.
Warnings
Solutions containing sodium ions should be used with great care, if at all, in patients with congestive heart failure, severe renal insufficiency and in clinical states in which there exists edema with sodium retention.
Excessive administration of potassium-free solutions may result in significant hypokalemia.
In patients with diminished renal function, administration of solutions containing sodium ions may result in sodium retention.
The intravenous administration of these solutions can cause fluid and/or solute overloading resulting in dilution of serum electrolyte concentrations, overhydration, congested states of pulmonary edema.
The risk of dilutional states is inversely proportional to the electrolyte concentrations of administered parenteral solutions. The risk of solute overload causing congested states with peripheral and pulmonary edema is directly proportional to the electrolyte concentrations of such solutions.
Precautions
Clinical evaluation and periodic laboratory determinations are necessary to monitor changes in fluid balance, electrolyte concentrations and acid-base balance during prolonged parenteral therapy or whenever the condition of the patient warrants such evaluation.
Caution must be exercised in the administration of parenteral fluids, especially those containing sodium ions to patients receiving corticosteroids or corticotrophin.
Do not administer unless solution is clear and container is undamaged. Discard unused portion.
Adverse Reactions
Clinical Trials Experience
Reactions which may occur because of the solution or the technique of administration include febrile response, infection at the site of injection, venous thrombosis or phlebitis extending from the site of injection, extravasation and hypervolemia.
If an adverse reaction does occur, discontinue the infusion, evaluate the patient, institute appropriate therapeutic countermeasures and save the remainder of the fluid for examination if deemed necessary.
Postmarketing Experience
There is limited information regarding Postmarketing Experience of Sodium chloride (injection) in the drug label.
Drug Interactions
There is limited information regarding Sodium chloride (injection) Drug Interactions in the drug label.
Animal reproductive studies have not been conducted with sodium chloride. It is also not known whether sodium chloride can cause fetal harm when administered to a pregnant woman or can affect reproduction capacity. Sodium chloride should be given to a pregnant woman only if clearly needed.
There is no Australian Drug Evaluation Committee (ADEC) guidance on usage of Sodium chloride (injection) in women who are pregnant.
Labor and Delivery
There is no FDA guidance on use of Sodium chloride (injection) during labor and delivery.
Nursing Mothers
Caution should be exercised when Sodium Chloride Injection, USP is administered to a nursing women.
Pediatric Use
The safety and effectiveness in the pediatric population are based on the similarity of the clinical conditions of the pediatric and adult populations. In neonates or very small infants the volume of fluid may affect fluid and electrolyte balance.
Geriatic Use
Clinical studies of 0.9% Sodium Chloride Injection, USP did not include sufficient numbers of subjects aged 65 and over to determine whether they respond differently from younger subjects. Other reported clinical experience has not identified differences in responses between elderly and younger patients. In general, dose selection for an elderly patient should be cautious, usually starting at the low end of the dosing range, reflecting the greater frequency of decreased hepatic, renal, or cardiac function, and of concomitant disease or other drug therapy.
This drug is known to be substantially excreted by the kidney, and the risk of toxic reactions to this drug may be greater in patients with impaired renal function. Because elderly patients are more likely to have decreased renal function, care should be taken in dose selection, and it may be useful to monitor renal function.
Gender
There is no FDA guidance on the use of Sodium chloride (injection) with respect to specific gender populations.
Race
There is no FDA guidance on the use of Sodium chloride (injection) with respect to specific racial populations.
Renal Impairment
There is no FDA guidance on the use of Sodium chloride (injection) in patients with renal impairment.
Hepatic Impairment
There is no FDA guidance on the use of Sodium chloride (injection) in patients with hepatic impairment.
Females of Reproductive Potential and Males
There is no FDA guidance on the use of Sodium chloride (injection) in women of reproductive potentials and males.
Immunocompromised Patients
There is no FDA guidance one the use of Sodium chloride (injection) in patients who are immunocompromised.
There is limited information regarding Monitoring of Sodium chloride (injection) in the drug label.
IV Compatibility
There is limited information regarding IV Compatibility of Sodium chloride (injection) in the drug label.
Overdosage
In the event of overhydration or solute overload, re-evaluate the the patient and institute appropriate corrective measures.
Pharmacology
There is limited information regarding Sodium chloride (injection) Pharmacology in the drug label.
Mechanism of Action
There is limited information regarding Sodium chloride (injection) Mechanism of Action in the drug label.
Structure
0.9% Sodium Chloride Injection, USP is sterile and nonpyrogenic. It is a parenteral solution containing sodium chloride in water for injection intended for intravenous administration.
Each 100 mL of 0.9% Sodium Chloride Injection, USP contains 900 mg sodium chloride in water for injection. Electrolytes per 1000 mL: sodium (Na+) 154 mEq; chloride (Cl-) 154 mEq. The osmolarity is 308 mOsmol/L (calc).
The pH is 5.6 (4.5 - 7.0).
This solution contains no bacteriostat, antimicrobial agent or added buffer and is intended only as a single-dose injection. When smaller doses are required, the unused portion should be discarded.
0.9% Sodium Chloride Injection, USP is a parenteral fluid and electrolyte replenisher.
Sodium Chloride, USP is chemically designated NaCl, a white crystalline powder freely soluble in water.
Water for Injection, USP is chemically designed H2O.
The flexible plastic inner bag is fabricated from a specially compounded polyvinylchloride. Water may permeate through the inner bag into the outerwrap in quantities insufficient to significantly affect the solution. Solutions in contact with the plastic inner bag can leach out certain of its chemical components in very small amounts; however, the safety of the plastic formulation is supported by biological testing.
Exposure to temperatures above 25°C (77°F) during transport and storage will lead to minor losses in moisture content. Higher temperatures lead to greater losses. It is unlikely that these minor losses will lead to clinically significant changes within the expiration period.
There is limited information regarding Pharmacodynamics of Sodium chloride (injection) in the drug label.
Pharmacokinetics
When administered intravenously, these solutions provide a source of water and electrolytes.
Solutions which provide combinations of hypotonic or isotonic concentrations of sodium chloride are suitable for parenteral maintenance or replacement of water and electrolyte requirements.
Isotonic concentrations of sodium chloride are suitable for parenteral replacement of chloride losses that exceed or equal the sodium loss. Hypotonic concentrations of sodium chloride are suited for parenteral maintenance of water requirements when only small quantities of salt are desired. A hypertonic concentration of sodium chloride may be used to repair severe salt depletion syndrome.
Sodium chloride in water dissociates to provide sodium (Na+) and chloride (Cl-) ions. Sodium (Na+) is the principle cation of the extracellular fluid and plays a large part in the therapy of fluid and electrolyte disturbances. Chloride (Cl-) has an integral role in buffering action when oxygen and carbon dioxide exchange occurs in the red blood cells. The distribution and excretion of sodium (Na+) and chloride (Cl-) are largely under the control of the kidney which maintains a balance between intake and output.
Water is an essential constituent of all body tissues and accounts for approximately 70% of total body weight. Average normal adult daily requirements range from two to three liters (1.0 to 1.5 liters each for insensible water loss by perspiration and urine production).
Water balance is maintained by various regulatory mechanisms. Water distribution depends primarily on the concentration of electrolytes in the body compartments and sodium (Na+) plays a major role in maintaining physiologic equilibrium.
Nonclinical Toxicology
Carcinogenesis, Mutagenesis, Impairment of Fertility:Studies have not been performed with Sodium Chloride Injection, USP to evaluate the potential for carcinogenesis, mutagenesis or impairment of fertility.
Clinical Studies
There is limited information regarding Clinical Studies of Sodium chloride (injection) in the drug label.
How Supplied
0.9% Sodium Chloride Injection, USP is supplied in single-dose flexible plastic containers as follows:
Exposure of pharmaceutical products to heat should be minimized. Avoid excessive heat. Protect from freezing. Store at 20° to 25°C (68° to 77°F). [See USP Controlled Room Temperature.] However, brief exposure up to 40°C does not adversely affect the product.
Storage
There is limited information regarding Sodium chloride (injection) Storage in the drug label.
Images
Drug Images
{{#ask: Page Name::Sodium chloride (injection)
|?Pill Name
|?Drug Name
|?Pill Ingred
|?Pill Imprint
|?Pill Dosage
|?Pill Color
|?Pill Shape
|?Pill Size (mm)
|?Pill Scoring
|?NDC
|?Drug Author
|format=template
|template=DrugPageImages
|mainlabel=-
|sort=Pill Name
}}
There is limited information regarding Patient Counseling Information of Sodium chloride (injection) in the drug label.
Precautions with Alcohol
Alcohol-Sodium chloride (injection) interaction has not been established. Talk to your doctor about the effects of taking alcohol with this medication.
Brand Names
There is limited information regarding Sodium chloride (injection) Brand Names in the drug label.
Look-Alike Drug Names
There is limited information regarding Sodium chloride (injection) Look-Alike Drug Names in the drug label.
01.png){kind=link}
02.png){kind=link}