Radial catheterization procedure: Difference between revisions
| Line 11: | Line 11: | ||
==Procedure== | ==Procedure== | ||
# Before the start of the procedure a “time out” should be taken to revise the indication, important labs, and the patency of the wrist circulation as discussed previously. [[Allen's test]] or[[Barbeau test]] | |||
# Make sure that all of the equipment are ready and recheck the sizes . | |||
# The wrist should be shaved (if necessary) and cleansed in the usual sterile fashion. In addition, the groin should be prepped in case of access failure or the need for urgent [[IABP]] or a temporary venous [[pacemaker]] | # The wrist should be shaved (if necessary) and cleansed in the usual sterile fashion. In addition, the groin should be prepped in case of access failure or the need for urgent [[IABP]] or a temporary venous [[pacemaker]] | ||
# [[Intravenous]] (IV) line should be started on the contralateral extremity. If an IV should be placed in the intervention extremity, it must be placed proximal to wrist preferably at the level of elbow. | # [[Intravenous]] (IV) line should be started on the contralateral extremity. If an IV should be placed in the intervention extremity, it must be placed proximal to wrist preferably at the level of elbow. | ||
# | # Sterilization of the whole arm should be done using the standard sterile techniques and covered in sterile drapes except for the region of the radial artery - distal part of the palmar surface of the forearm - which is left exposed for an easier access. | ||
# | # Most operators prefer to give anxiolytics e.g [[Midazolam]] (1-2 mg) before the start of the procedure to decrease patient anxiety and hence decrease radial spasm. | ||
# The arm should be fully extended; slightly elevated with full supination, and the wrist is hyperextended. | |||
# | # Palpation of the radial artery against the styloid process of the radius with middle three fingers, to find the point of maximal impulse "PMI" is done. | ||
# At 45° angle, an 18-21 guage needle should be introduced and an exchange length 0.035-0.038 inch J-tip guidewire is inserted | # An amount of 0.5cc to 1.0 cc of local anesthetic is injected superficially over the PMI | ||
# Radial sheath of 23cm long and 4-6Fr size should then be introduced | # At 45° angle, an 18-21 guage needle should be introduced and an exchange length 0.035-0.038 inch J-tip guidewire is inserted. | ||
# Radial sheath of 23cm long and 4-6Fr size should then be introduced. | |||
# Using a rotating arm board under the shoulder facilitates ease of movement and placement of radial sheath | # Using a rotating arm board under the shoulder facilitates ease of movement and placement of radial sheath | ||
# Through sidearm of the sheath, 5000U of [[heparin]] should be administered | # Through sidearm of the sheath, 5000U of [[heparin]] should be administered | ||
| Line 26: | Line 29: | ||
# Hemostasis is achieved by direct pressure at the puncture site at the end of the procedure after removal of radial sheath | # Hemostasis is achieved by direct pressure at the puncture site at the end of the procedure after removal of radial sheath | ||
# Radial pulse should be monitored after the procedure for several hours regularly. | # Radial pulse should be monitored after the procedure for several hours regularly. | ||
Radial sheath kits are now available which contain hydrophilic coated sheaths in sizes 4-6Fr equipped with graduated introducers, various micropuncture needles and guidewire. | |||
Radial sheath kits are now available which contain hydrophilic coated sheaths in sizes 4-6Fr equipped with graduated introducers, various micropuncture needles and guidewire. | |||
'''Below is a video demonstrating radial artery approach in cardiac catheterization followed by application of TR band''' | '''Below is a video demonstrating radial artery approach in cardiac catheterization followed by application of TR band''' | ||
Revision as of 16:16, 14 August 2014
|
Radial artery cathetarization Microchapters |
|
Case Studies |
|---|
|
Radial catheterization procedure On the Web |
|
American Roentgen Ray Society Images of Radial catheterization procedure |
|
Directions to Hospitals Treating Radial artery cathetarization |
|
Risk calculators and risk factors for Radial catheterization procedure |
Editor-In-Chief: C. Michael Gibson, M.S., M.D. [1]; Associate Editor-In-Chief: Varun Kumar, M.B.B.S.; Lakshmi Gopalakrishnan, M.B.B.S.
Overview
The transradial approach (TRA) for coronary/cardiac catheterization is slightly more challenging than the transfemoral route. It requires more maneuvers and catheter steering along the course of the radial artery to reach the level of the coronary sinus in the ascending aorta. The right transradial approach is usually preferred over the left side due to the ease of accessibility for the operating physician.
Catheter/GuideWire Selection
Catheter selection is an important key in the success of the procedure. Standard catheters (e.g Judkin's Left and Judkin’s right) can be used for the TRA. However due to the common anomalies that could be seen along the course of the radial, subclavien, and axillary arteries, special “dedicated Radial Catheters” had been developed (e.g. Tiger, Jacky, and Kimmy). The most commonly used guidewires are those with hydrophilic coating, due to the expected tortuosity of the arterial course.
Procedure
- Before the start of the procedure a “time out” should be taken to revise the indication, important labs, and the patency of the wrist circulation as discussed previously. Allen's test orBarbeau test
- Make sure that all of the equipment are ready and recheck the sizes .
- The wrist should be shaved (if necessary) and cleansed in the usual sterile fashion. In addition, the groin should be prepped in case of access failure or the need for urgent IABP or a temporary venous pacemaker
- Intravenous (IV) line should be started on the contralateral extremity. If an IV should be placed in the intervention extremity, it must be placed proximal to wrist preferably at the level of elbow.
- Sterilization of the whole arm should be done using the standard sterile techniques and covered in sterile drapes except for the region of the radial artery - distal part of the palmar surface of the forearm - which is left exposed for an easier access.
- Most operators prefer to give anxiolytics e.g Midazolam (1-2 mg) before the start of the procedure to decrease patient anxiety and hence decrease radial spasm.
- The arm should be fully extended; slightly elevated with full supination, and the wrist is hyperextended.
- Palpation of the radial artery against the styloid process of the radius with middle three fingers, to find the point of maximal impulse "PMI" is done.
- An amount of 0.5cc to 1.0 cc of local anesthetic is injected superficially over the PMI
- At 45° angle, an 18-21 guage needle should be introduced and an exchange length 0.035-0.038 inch J-tip guidewire is inserted.
- Radial sheath of 23cm long and 4-6Fr size should then be introduced.
- Using a rotating arm board under the shoulder facilitates ease of movement and placement of radial sheath
- Through sidearm of the sheath, 5000U of heparin should be administered
- To reduce spasm, 500 micrograms of diltiazem can also be administered via the sidearm
- Coronary catheters are then advanced along the guidewire into aorta
- Left and right coronary arteries are then catheterized using Judkins, Amplatz or multipurpose catheter
- Hemostasis is achieved by direct pressure at the puncture site at the end of the procedure after removal of radial sheath
- Radial pulse should be monitored after the procedure for several hours regularly.
Radial sheath kits are now available which contain hydrophilic coated sheaths in sizes 4-6Fr equipped with graduated introducers, various micropuncture needles and guidewire.
Below is a video demonstrating radial artery approach in cardiac catheterization followed by application of TR band {{#ev:youtube|XhZroo-_oUA}}